Which setup is correct when you configure Cisco UCS B-Series VICs (M81KR/12xx VICs) for Cisco Unified Contact Center Enterprise on Cisco UCS B-Series deployments?
A) Enable Fabric Failover as an extra redundancy measure so that traffic from the UCS B-Series blade has the HA paths. (Both FI-A and FI-B paths are used in a failover scheme.)
B) Disable the Fabric Failover option.
C) Disregard this option because either mode is fine with Cisco Unified CCE on UCS B-Series deployments.
D) Enable this Fabric Failover when the connected upstream network is operating in a Common Layer 2 domain.
E) Disable this Fabric Failover when the connected upstream network is operating in a Disjointed Layer 2 domain.

Question

Quizplus · Accepted Answer

Fabric Failover should be disabled because it can cause issues with network stability and redundancy in UCS environments, especially when using Cisco Unified Contact Center Enterprise.

Which Setup Is Correct When You Configure Cisco UCS B-Series