Question 1

What are two characteristics of Cisco ACI and Spanning Tree Protocol interaction? (Choose two.)

Accepted Answer

The answer of What are two characteristics of Cisco ACI...

Question 2

Cisco ACI fabric is migrated from network-centric mode to application-centric mode. What is possible in an application-centric design?

Accepted Answer

In an application-centric design, you can create additional Endpoint Groups (EPGs) under one bridge domain, allowing for more granular policy application and network segmentation based on application needs.

Question 3

Refer to the exhibit. Which two configuration steps are required in ISN for Cisco ACI Multi-Site setup? (Choose two.)

Accepted Answer

The answer of  Refer to the exhibit. Which two...

Question 4

An engineer creates the objects that must be deployed at each site in Cisco ACI Multi-Site Orchestrator. Which action should be taken before the schema can be associated with the newly configured site?

Accepted Answer

The templates must be attached to the newly configured site before the schema can be associated with it in Cisco ACI Multi-Site Orchestrator.

Question 5

An engineer configures a new Cisco ACI Multi-Pod and must set up the link between the spine and the IPN device. Which three actions should be taken to accomplish this goal? (Choose three.)

Accepted Answer

The answer of An engineer configures a new Cisco ACI...

Question 6

Refer to the exhibit. A network engineer configures a Layer 4 to Layer 7 device for an outside routed firewall that is connected to POD-1 inside a Cisco ACI fabric that consists of two pods. All traffic from POD-1 or POD-2 that uses the L3Out should pass through the routed firewall. Which Function Type must be implemented in the service graph for POD-2 to use L3Out?

Accepted Answer

The answer of  Refer to the exhibit. A network...

Question 7

Which firewall connection allows for the integration of service nodes in transparent mode with a Cisco ACI Multi-Pod setup?

Accepted Answer

The answer of Which firewall connection allows for the integration...

Question 8

An organization deploys active-active data centers and active-standby firewalls in each data center. Which action should be taken in a Cisco ACI Multi-Pod to maintain traffic symmetry through the firewalls?

Accepted Answer

The answer of An organization deploys active-active data centers and...

Question 9

An engineer configures a new Cisco ACI Multi-Pod setup. Which action should be taken for fabric discovery to be successful for the nodes in Pod 2?

Accepted Answer

The answer of An engineer configures a new Cisco ACI...

Question 10

What is a characteristic of a stretched bridge domain solution between Cisco ACI sites with Layer 2 flood disabled?

Accepted Answer

The answer of What is a characteristic of a stretched...

Question 11

Where are STP BPDUs flooded in Cisco ACI fabric?

Accepted Answer

STP BPDUs are flooded in the bridge domain VLAN in Cisco ACI fabric. This is because the bridge domain is responsible for Layer 2 forwarding and STP is a Layer 2 protocol.

Question 12

Refer to the exhibit. A customer implements Cisco ACI Multi-Site with default MTU settings between two sites. Which configuration should be applied on the interface Eth1/10 on the ISN-1 device?

Accepted Answer

The answer of  Refer to the exhibit. A customer...

Question 13

A network engineer configured an active-active firewall cluster that is stretched across separate pods in the Cisco ACI fabric. Which two implementation setups for anycast services are available? (Choose two.)

Accepted Answer

The answer of A network engineer configured an active-active firewall...

Question 14

Refer to the exhibit. An engineer extends a Cisco ACI Multi-Pod setup to a Cisco ACI Multi-Site implementation. Which action allows the interconnection?

Accepted Answer

The answer of  Refer to the exhibit. An engineer...

Question 15

What are two characteristics of Cisco ACI interaction with MSTP? (Choose two.)

Accepted Answer