Ready to test your Knowledge?
Try out our new practice tests completely free!
exam preparation banner icon

Heavy Duty Truck Systems

Education

Quiz 3 :

Tools and Fasteners

Quiz 3 :

Tools and Fasteners

search
arrow
Which of the statements below about the use of hand tools is TRUE?
Free
Multiple Choice
Answer:

Answer:

B

arrow
When measuring backlash between gears,which of the following measuring tools should be used to provide an accurate reading?
Free
Multiple Choice
Answer:

Answer:

D

arrow
The use of which of the following hand and shop tools requires you to wear eye protection?
Free
Multiple Choice
Answer:

Answer:

D

arrow
What should be used to mark the start point before drilling a hole in steel?
Multiple Choice
Answer:
arrow
Technician A says to replace all original Grade 5 fasteners with Grade 8 when performing suspension repairs.Technician B says that a Grade 8 rated Huck fastener may be replaced with a Grade 8 nut and bolt.Who is right?
Multiple Choice
Answer:
arrow
Which of the following matches the term hex socket?
Multiple Choice
Answer:
arrow
How is an arbor press actuated?
Multiple Choice
Answer:
arrow
A wrench with open-end jaws at one end and box-end jaws at the other,both of the same nominal dimension,is known as a
Multiple Choice
Answer:
arrow
Through how many thimble rotations must a metric micrometer be turned to make the spindle move exactly 1.25 mm?
Multiple Choice
Answer:
arrow
Which of the following tools should be used to cut external (outside)threads on bolts,rods,and pipes?
Multiple Choice
Answer:
arrow
Which of the following types of pliers would be most suitable for intricate electrical work?
Multiple Choice
Answer:
arrow
When using a hacksaw blade to cut steel,which of the following statements is False?
Multiple Choice
Answer:
arrow
Which of these statements about a standard micrometer is TRUE?
Multiple Choice
Answer:
arrow
When measuring the thickness of a component measuring around .0015 inches,which of the following measuring tools would be most accurate?
Multiple Choice
Answer:
arrow
What is an advantage of a Posi-Drive screw over a Phillips screw?
Multiple Choice
Answer:
arrow
Through how many thimble rotations must a standard micrometer be turned to make the spindle move exactly 1/4 inch?
Multiple Choice
Answer:
arrow
Which of the following statements about hand tools is NOT true?
Multiple Choice
Answer:
arrow
When selecting a hacksaw blade to cut light angle iron,what is the recommended TPI?
Multiple Choice
Answer:
arrow
What should be done with a hammer that has a damaged wooden handle?
Multiple Choice
Answer:
arrow
Which of the following wrenches is most suitable for tightening tubing and hose fittings like those found on diesel fuel systems or hydraulic hoses?
Multiple Choice
Answer:
Showing 1 - 20 of 39