Ready to test your Knowledge?
Try out our new practice tests completely free!
exam preparation banner icon

Heavy Duty Truck Systems

Education

Quiz 22 :

Driveshaft Assemblies

Quiz 22 :

Driveshaft Assemblies

search
arrow
Which of the following terms is another way of describing a U-joint cross?
Free
Multiple Choice
Answer:

Answer:

A

arrow
Which of the following types of universal joint damage would most likely result from improper installation?
Free
Multiple Choice
Answer:

Answer:

D

arrow
Which of the following is a function of the slip yoke used on a driveshaft?
Free
Multiple Choice
Answer:

Answer:

B

arrow
Which of the following components consists of a hardened,splined stubb,welded to the end of a driveshaft tube,and mates to a yoke with matching internal splines?
Multiple Choice
Answer:
arrow
Which of the following operating conditions requires the most frequent lubrication of the driveshaft?
Multiple Choice
Answer:
arrow
Which of the following describes a broken back driveline arrangement?
Multiple Choice
Answer:
arrow
When a universal joint assembly is equipped with a standpipe,what is the function of the standpipe?
Multiple Choice
Answer:
arrow
What factors determine the required driveshaft diameter and wall thickness?
Multiple Choice
Answer:
arrow
A technician greasing a driveshaft slip spline assembly applies lubricant until it appears at the pressure relief hole.What should be done next?
Multiple Choice
Answer:
arrow
How often should a typical driveshaft hanger bearing be lubricated?
Multiple Choice
Answer:
arrow
Which of the following are recommended lubricants for heavy-duty truck U-joints?
Multiple Choice
Answer:
arrow
Which of the following would represent ideal operating conditions for a pair of universal joints on a propeller shaft?
Multiple Choice
Answer:
arrow
Why should a driveshaft maintain flexibility while continuously transferring torque between powertrain components?
Multiple Choice
Answer:
arrow
When are the two universal joints on a driveshaft operating in-phase?
Multiple Choice
Answer:
arrow
When a one-piece,parallel-joint driveline arrangement with 2 universal joints is used,which of its angles must be equal and opposite?
Multiple Choice
Answer:
arrow
All of the following conditions can cause driveshaft vibration EXCEPT:
Multiple Choice
Answer:
arrow
When lubricating universal joints,which of the following is best practice?
Multiple Choice
Answer:
arrow
What is usually considered to be the maximum recommended length for a single-piece driveshaft operating at speeds of 3,000 rpm?
Multiple Choice
Answer:
arrow
When greasing a driveshaft U-joint,grease exits from three trunnion seals but not the fourth.What should be done next?
Multiple Choice
Answer:
arrow
Which of the following components contains a forged journal cross and trunnions?
Multiple Choice
Answer:
Showing 1 - 20 of 50