Ready to test your Knowledge?
Try out our new practice tests completely free!
exam preparation banner icon

Automotive Technology

Trade & Technology

Quiz 43 :

Automatic Transmission and Transaxle Service

Quiz 43 :

Automatic Transmission and Transaxle Service

search
arrow
When should the ATF level be checked on most vehicles?
Free
Multiple Choice
Answer:

Answer:

D

arrow
The transmission's fluid and filter should be changed only when there is an indication of oxidation or contamination.
Free
True False
Answer:

Answer:

False

arrow
An engine vacuum leak can cause degraded shift quality.
Free
True False
Answer:

Answer:

True

arrow
A leaking transmission case can often be repaired with an epoxy-based sealant.
True False
Answer:
arrow
The gear range selector linkage must be adjusted properly to prevent fluid line pressure loss from the manual valve.
True False
Answer:
arrow
Air pressure tests are performed during disassembly to locate leaking seals and during reassembly to check the operation of the clutches and servos.
True False
Answer:
arrow
Synthetic fluids tend to look and smell burnt after normal use; therefore, the appearance and smell of these fluids is not a good indicator of the fluid's condition.
True False
Answer:
arrow
On all automatic transmissions, the fluid level is always checked with the engine running and the transmission in park.
True False
Answer:
arrow
Some manufacturers do not recommend pressure testing automatic transmissions.
True False
Answer:
arrow
Incorrect pressure readings may reveal a possible problem in which of the following hydraulic circuits?
Multiple Choice
Answer:
arrow
Two technicians are discussing transmission fluid. Technician A says transmission fluid is red in color and has no dark or metallic particles suspended in it. Technician B says synthetic ATF is normally a darker red than petroleum-based fluid and tends to look and smell burnt after normal use. Who is correct?
Multiple Choice
Answer:
arrow
Spool valves, springs, and other components of the valve body should be cleaned using a wiping rag or paper towel.
True False
Answer:
arrow
Dexron III transmission fluid can be used in all automatic transmissions.
True False
Answer:
arrow
Most transmission shops rebuild the torque converter when overhauling the transmission.
True False
Answer:
arrow
A plugged transmission cooler line or a restricted cooler can cause the vehicle to stall when shifted into reverse.
True False
Answer:
arrow
Slippage during shifting may indicate that a band needs adjustment.
True False
Answer:
arrow
A leaking transmission pump seal can be replaced without removing the transmission.
True False
Answer:
arrow
Some manufacturers require replacement of the transmission cooler whenever the transmission is overhauled.
True False
Answer:
arrow
When performing a stall test, the throttle should be held wide open for ten seconds.
True False
Answer:
arrow
A faulty wiring connector will not affect shift timing.
True False
Answer:
Showing 1 - 20 of 85