You have been tasked with the configuration of a Juniper switch, and have been told to restrict the number of MAC addresses allowed in the MAC address table. What command should you use?
A) set max-mac
B) set total-macs
C) mac-address limit
D) mac-limit

Question

Quizplus · Accepted Answer

The command "mac-limit" is used to restrict the number of MAC addresses allowed in the MAC address table on a Juniper switch. The command is entered in the configuration mode and can specify a limit for the entire switch or for a specific VLAN. The other options listed (set max-mac, set total-macs, and mac-address limit) are not valid commands for this purpose.

You Have Been Tasked with the Configuration of a Juniper