Which of the following commands is used to setup a trunk port on a 2960 switch?
A)switchtrunk on
B)switchport mode trunk
C)trunk switch
D)switchport trunk on

Question

Quizplus · Accepted Answer

You can use the switchport mode trunk command to setup a trunk port on a 2960 switch.
Key Takeaway: Setting up a switch port to trunk mode allows all VLAN information to pass down the link. Every port on a Cisco switch is either an access port or a trunk port. Access ports belong to a single VLAN and do not provide identification on the frames that are passed between switches. They also carry traffic that comes from only the VLAN assigned to the port. A trunk port is, by default, a member of all the VLANs that exist on the switch and carries traffic for all those VLANs between the switches.

Which of the Following Commands Is Used to Setup a Trunk