A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link. 
The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?
A) The OSPF area is not configured properly.
B) The priority on R1 should be set higher.
C) The cost on R1 should be set higher.
D) The hello and dead timers are not configured properly.
E) A backup designated router needs to be added to the network.
F) The OSPF process ID numbers must match.
Correct Answer:
Verified
Q184: If all OSPF routers in a single
Q185: Refer to the exhibit. Which two statements
Q186: Refer to the exhibit. When running EIGRP,
Q187: Refer to the exhibit. If R1 receives
Q188: Which three describe the reasons large OSPF
Q190: Which command is used to display the
Q191: Refer to the exhibit. On R1 which
Q192: Refer to the exhibit. C-router is to
Q193: Which two circumstances can prevent two routers
Q194: Which command should you enter to view
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents