In the event you are configuring a serial interface as a DCE (data communication equipment), you will need to add the ____ [bandwidth in bits per second] command.
A) clockrate
B) baud
C) bbps
D) baudrate

Question

Quizplus · Accepted Answer

When configuring a serial interface as a DCE, you need to set the clock rate which is measured in bits per second (bps) and is used to synchronize the timing of data transmission between the DCE and the DTE (data terminal equipment). Therefore, the correct command to use is "clockrate".

In the Event You Are Configuring a Serial Interface as a DCE