When using a DMM in resistance mode across terminals Cand D on a 9-pin J1939 receptacle,40 ohms is displayed on the meter.Which of the following is most likely?
A) One missing terminating resistor
B) Both terminating resistors missing
C) Three terminating resistors on the bus
D) The bus is down
Correct Answer:
Verified
Q47: Technician A says that the ECPC valves
Q48: Which of the following correctly describes the
Q49: What is required to access DTCs in
Q50: What type of fluid level sensor is
Q51: Which of the following should be true
Q52: Which of the following pressure values would
Q53: What effects clutch control in a Caterpillar
Q55: What Allison software component can be used
Q56: What is used to manage variable bleed
Q57: On an Allison TC10,what do the 4th
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents