Deck 39: Programming a PLC

Question 1

Programmable logic controllers are all programmed the same way.

Answer 1

False

Question 2

With programmable logic controllers, each line of logic must end with a(n) ____________________.

Answer 2

coil

Question 3

Figure 39-2

When the START button is pushed in the accompanying figure, relay coil CR is energized. This causes all CR contacts to close. Contact CR-1 is a(n) ____________________ used to maintain the circuit to coil CR when the START button is released.

Answer 3

holding contact

Question 4

As far as programmable logic controllers are concerned, the program will scan in the order that it is entered.

Question 5

Figure 39-12

In the accompanying figure, when contact 1 closes, coil 100 will always be the ____________________ that turns on because it is scanned before coil 101.

Question 6

How do programmable logic controllers scan a program?

Question 7

Figure 39-1

In the accompanying figure, when the tank is empty, the ____________________ de-energizes solenoid C.

Question 8

In the accompanying figure, what happens when the motor turns off?

Question 9

Most programmable logic controllers (PLCs) contain a timer that runs continually when the PLC is in the RUN mode. What is the function of this timer?

Question 10

Contacts that exist in the logic of the program only are ____________________.

Question 11

Figure 38-11

The circuit shown in the above figure contains two control relay coils. A normally closed contact, controlled by the opposite relay, is connected in series with each coil. When the switch is closed, which relay will turn on and which will be locked out of the circuit?

Question 12

Figure 39-1

In the accompanying figure, what happens when the tank is filled?

Question 13

As a general rule, for programmable logic controllers, coils can be connected in a series.

Question 14

Programmable logic controllers operate by scanning the program that has been entered into memory.

Question 15

Programmable logic controllers know what device is connected to which input.