Deck 7: Other Views

Question 1

Dimensions given on views that have a(n) ____________________ break are the true sizes.

Answer 1

conventional

Question 2

It is possible that lines representing two different surfaces of an object shown in one view would, when shown in another view, appear as one line.

Answer 2

True

Question 3

The development of the auxiliary view is sometimes shown by lines projected ___________________ from the slanted surface.

Answer 3

perpendicularly

Question 4

Dimensions shown on the developed view include any ____ necessary for bending or rolling.

A) calculations
B) variations
C) allowances
D) variances

Question 5

Each enlarged detail is identified by a ____.

A) color
B) letter or number
C) symbol
D) legend

Question 6

A ____ indicates that a section of the metal has been removed.

A) break line
B) delete line
C) break symbol
D) delete symbol

Question 7

If the metal has a uniform structural shape throughout its length, a reduced length can be shown by means of a conventional ____________________ symbol.

Question 8

The auxiliary view represents a view of the slanted surface from a position ____ to an object.

A) at acute angles
B) at left angles
C) at right angles
D) parallel

Question 9

On a print, the location where the metal has been removed is indicated by ____.

A) break lines
B) delete lines
C) break symbols
D) delete symbols

Question 10

The use of a reduced scale size can be overcome by showing an enlarged detail.

Question 11

When an error is discovered on a drawing while in use in the shop, quite often the error will be marked with ____ pencil.

A) red or blue
B) red or yellow
C) green or yellow
D) blue or green

Question 12

Many of the structural shapes to be drawn are too long to be shown on a print in their true size.

Question 13

When both side views are included on a print, they are invariably shown as ____________________ views.

Question 14

When an object has a slanted (oblique) face, a(n) ____ view may be included on the print to show the plane of the slanted surface more clearly.

A) alternate
B) auxiliary
C) representative
D) parallel

Question 15

The number of auxiliary views required depends on the number of ____ an object has.

A) oblique faces
B) alternate surfaces
C) skewed surfaces
D) slanted surfaces

Question 16

In many cases, a developed view is not necessary.

Question 17

When revisions are required due to changes in design, they are often made on the original of the blueprint.

Question 18

A(n) ____ view illustrates the part exactly as it must be prepared before any bending or rolling is performed.

A) developed
B) auxiliary
C) surfaced
D) dimensional

Question 19

A(n) ____ view is used to indicate the locations of holes in sheets or plates that are to be rolled or shaped into cylindrical forms.

A) auxiliary
B) surfaced
C) dimensional
D) developed

Question 20

A(n) ____________________ view is a view of a part as it appears when stretched or laid out on a flat surface.