When robots are moved during programming by using the tool mode, the movement follows the universal robot coordinate system.
Correct Answer:
Verified
Q21: The non -servo robot controller is most
Q22: In point -to -point program control each
Q23: In straight line or linear program control
Q24: Continuous -path program control is used where
Q25: Linear path robot programs would have more
Q27: If you were programming a robot to
Q28: A task point graph is a technique
Q29: The basic program structure starts with two
Q30: Robot programs are divided into tasks and
Q31: Non -servo robots are programmed in either
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents