You are a Cisco engineer, and just configured a router port using the following three commands.
(1) R1(config)# interface Fastethernet0/0
(2) R1(config-if)# ip address 172.20.1.254 255.255.255.0
(3) R1(config-if)# no shutdown
Then, the commands must create a(n) _________ entry in the routing table?
A) directly connected route
B) static route
C) dynamic route
D) default route
E) The commands do not add an entry to the routing table

Question

You are a Cisco engineer, and just configured a router port using the following three commands.
(1) R1(config)# interface Fastethernet0/0
 (2) R1(config-if)# ip address 172.20.1.254 255.255.255.0
 (3) R1(config-if)# no shutdown
 Then, the commands must create a(n) _________ entry in the routing table?
A) directly connected route 
B) static route 
C) dynamic route 
D) default route 
E) The commands do not add an entry to the routing table

Quizplus · Accepted Answer

The commands configure a static IP address on the FastEthernet0/0 interface and enable the interface with the "no shutdown" command. This creates a directly connected network route in the router's routing table.

You Are a Cisco Engineer, and Just Configured a Router