An engineer needs to configure LLDP to send the port description time length value (TLV) . Which command sequence must be implemented?
A) switch(config-if) # lldp port-description switch(config-if) # lldp port-description
B) switch# lldp port-description switch#
C) switch(config-line) # lldp port-description switch(config-line) #
D) switch(config) # lldp port-description switch(config) #
Correct Answer:
Verified
Q116: A network engineer must configure the router
Q117: What is the same for both copper
Q118: Which technique can you use to route
Q119: Which two statements about the purpose of
Q120: Which two options are the best reasons
Q122: Refer to the exhibit. Which action is
Q123: Which mode allows access points to be
Q124: Which three statements are typical characteristics of
Q125: What are two benefits of using VTP
Q126: In a CDP environment, what happens when
Unlock this Answer For Free Now!
View this answer and more for free by performing one of the following actions
Scan the QR code to install the App and get 2 free unlocks
Unlock quizzes for free by uploading documents