Figure 1
-Refer to Figure 1. The source resistor, RS, that would self- bias this JFET at approximately VGS = -2 V is
A)220 ▲
B)470 ▲
C)360 ▲
D)1 M▲

Question

Figure 1
-Refer to Figure 1. The source resistor, RS, that would self- bias this JFET at approximately VGS = -2 V is
A)220 ▲ 
B)470 ▲ 
C)360 ▲ 
D)1 M▲

Quizplus · Accepted Answer

The correct resistor value for self-biasing a JFET at approximately VGS = -2 V is typically determined by the JFET's characteristics and desired operating point. A 470 Ω resistor is a common choice for moderate biasing levels in JFET circuits.

Figure 1 -Refer to Figure 1. the Source Resistor, RS, That Would