Deck 13: Introduction to Conventional Tolerancing

Question 1

A tolerance that is expressed as plus and minus values is a ____________________ tolerance.

Answer 1

bilateral

Question 2

MAX. is the abbreviation for maximum.

Answer 2

False

Question 3

The symbol/abbreviation for "number of places" is ____________________.

Answer 3

X

Question 4

When the upper and lower limits of a dimension have different values, the tolerances are called ___________________________________.

Question 5

When dimensions require greater accuracy than a general note on the drawing provides, individual tolerances or limits must be shown for that dimension.

Question 6

In metric dimensioning, the dimension and its tolerance need not be expressed to the same number of decimal places.

Question 7

In the limit dimensioning method, only the maximum and minimum dimensions are specified.

Question 8

When limit dimensions are applied to a diameter, the diameter symbol (Ø) is placed to the left of both the upper and lower limit dimension.

Question 9

The maximum and minimum sizes permitted for a specific dimension is the ____.

A) tolerance
B) limits of size
C) basic size
D) deviation

Question 10

When unilateral tolerancing is used in metric dimensioning and either the plus or minus value is nil, a single ____________________ is shown without a plus or minus sign.

Question 11

The intentional difference in size of mating parts is ____.

A) allowance
B) tolerance
C) limits of size
D) deviation

Question 12

In the dimension 2.500 .005, the .005 would be referred to as a(n) ____.

A) unequal bilateral tolerance
B) equal limits of size
C) equal unilateral tolerance
D) equal bilateral tolerance

Question 13

The total permissible variation in the size of a dimension is the ____.

A) tolerance
B) allowance
C) limits of size
D) deviattion

Question 14

The symbol for "plus or minus" is ____________________.

Question 15

The theoretical size from which the limits for that dimension are derived, by application of the allowance and tolerance, is the ____.

A) limits of size
B) allowance
C) basic size
D) tolerance