Deck 6: Using Wire Tables and Determining Conductor Sizes
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
سؤال
فتح الحزمة
قم بالتسجيل لفتح البطاقات في هذه المجموعة!
Unlock Deck
Unlock Deck
1/20
العب
ملء الشاشة (f)
Deck 6: Using Wire Tables and Determining Conductor Sizes
1
Describe the information in NEC Table 310.104(A), which specifies types of insulation.
The table is divided into seven main columns. The first column lists the trade name of the insulation; the second lists its identification code letter; the third column lists its maximum operating temperature; and the fourth shows its applications and where it is permitted to be used. The fifth column lists the material from which the insulation is made; the sixth states its thickness; and the last column lists the type of outer covering over the insulation.
2
If conductors are to be used in a location with a higher ambient temperature, the ampacity of the conductor must be ____.
A) kept constant
B) doubled
C) reduced
D) increased by 20 amperes
A) kept constant
B) doubled
C) reduced
D) increased by 20 amperes
C
3
What is the maximum operating temperature (in degrees Celsius) for Type SIS insulation?
A) 60
B) 90
C) 200
D) 250
A) 60
B) 90
C) 200
D) 250
B
4
An aluminum wire 2250 feet long cannot have a resistance greater than 0.2 ohm. What is the minimum size wire (in circular mils) that may be used?
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
5
According to the NEC, what five conditions must be met when conductors are in parallel?
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
6
After the conductors have been installed in conduits or raceways, it is accepted practice to test the installation for grounds and shorts. This test requires a(n) .
A) faradmeter
B) ammeter
C) voltmeter
D) ohmmeter
A) faradmeter
B) ammeter
C) voltmeter
D) ohmmeter
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
7
Twelve 14 AWG copper conductors with type RHW insulation are to be installed in conduit in an area with an ambient temperature of 110 degrees F (43 degrees C). What will be the ampacity of these conductors?
A) 4.1 amperes
B) 8.2 amperes
C) 16.4 amperes
D) 32.8 amperes
A) 4.1 amperes
B) 8.2 amperes
C) 16.4 amperes
D) 32.8 amperes
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
8
If you have a raceway with 35 current-carrying conductors, by what adjustment factor must you multiply the ampacity?
A) 0.2
B) 0.3
C) 0.4
D) 0.5
A) 0.2
B) 0.3
C) 0.4
D) 0.5
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
9
Find the resistance of 6 AWG copper wire 550 feet long. Assume a temperature of 20 degrees Celsius.
A) 0.00201 ohm
B) 0.159 ohm
C) 0.218 ohm
D) 4.59 ohm
A) 0.00201 ohm
B) 0.159 ohm
C) 0.218 ohm
D) 4.59 ohm
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
10
loss is caused by the continuous aligning and realigning of molecules, which produces heat due to friction.
A) Insulation
B) Hysteresis
C) Short
D) Ground
A) Insulation
B) Hysteresis
C) Short
D) Ground
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
11
The conductors of a single phase are not permitted to be run in metallic conduit because currents will be induced.
A) eddy
B) series
C) parallel
D) superconducting
A) eddy
B) series
C) parallel
D) superconducting
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
12
Currents of a three-phase system are degrees out of phase with each other.
A) 60
B) 90
C) 120
D) 180
A) 60
B) 90
C) 120
D) 180
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
13
How do wire material and diameter affect resistance?
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
14
How are wire installations tested for shorts and grounds?
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
15
The formula for calculating resistance of a certain length, size, and type of wire is: R = .
A) (K × L)/cmil
B) K/(L × cmil)
C) L/(K × cmil)
D) L × (cmil/K)
A) (K × L)/cmil
B) K/(L × cmil)
C) L/(K × cmil)
D) L × (cmil/K)
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
16
If the ambient temperature is above degrees Celsius, a correction factor must be applied to allowable ampacities for conductors.
A) 15
B) 20
C) 25
D) 30
A) 15
B) 20
C) 25
D) 30
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
17
The listed ampacities in the Code tables assume that the length of the conductor will not significantly increase the of the circuit.
A) ampacity
B) resistance
C) capacitance
D) inductance
A) ampacity
B) resistance
C) capacitance
D) inductance
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
18
A factor that determines the amount of current a conductor is permitted to carry is the type of used, which is the nonconductive covering around the wire.
A) insulation
B) raceway
C) busway
D) voltage
A) insulation
B) raceway
C) busway
D) voltage
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
19
Materials that increase their resistance with an increase of temperature have a coefficient of temperature.
A) decimal
B) constant
C) positive
D) negative
A) decimal
B) constant
C) positive
D) negative
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck
20
A conductor made out of what material is allowed to carry the most current, assuming that size and insulation type are held constant?
A) copper-clad aluminum
B) silicone
C) aluminum
D) copper
A) copper-clad aluminum
B) silicone
C) aluminum
D) copper
فتح الحزمة
افتح القفل للوصول البطاقات البالغ عددها 20 في هذه المجموعة.
فتح الحزمة
k this deck